![background image](http://html1.mh-extra.com/html/barco/encore-vpx/encore-vpx_installation-manual_3830692016.webp)
16
Encore VPx Installation Guide • 08-0311105-00 Rev 00
båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ
Installation
•
Distribute the units evenly to prevent hazardous conditions that may be created by
uneven weight distribution.
•
Rack mount the units from the front rack ears using four rack screws (not
supplied). Threads may be metric or otherwise — depending upon the rack type.
•
Install the
lower
of the two mounting holes first.
fåëí~ääáåÖ=smñ
This section provides detailed VPx installation procedures for the Encore configurations
listed below. Select the desired configuration, and follow all steps.
The following installation procedures are provided:
•
Installing VPX in a Wide Screen Configuration
•
Installing VPx in a Wide Screen Preview Configuration
•
Installing VPx in a Wide Screen Stack Configuration
Important
Only valid VPx configuration procedures are included below.
Note that steps for connecting peripherals (e.g., ScreenPRO-
II, Aux destinations, routers, tally, D/As, etc.) in a system are
not
covered below, but are fully covered in Chapter 3 of the
Encore Presentation System User’s Guide
.
Important
Software version 1.22 (or higher) must be installed first in
your Encore Controller, prior to connecting your VPx
processor(s).
Refer to Appendix C, “
Upgrading Software
”
in the
Encore Presentation System User’s Guide
for
complete upgrade instructions.