Barco CVM 2037, Инструкция по эксплуатации

Страница: 20 / 92

'
,N
c•
MONO COMB APT
1/4 ♦ ,
SIZE DELAY
COMMAND KEYS (continued)
MONO
Key for the selection between three different colour modes.
If a colour video signal is displayed in colour, consecutive
MONO
key presses permit the selection of :
COLOR OFF / FILTERED
COLOR OFF / FULL BANDWIDTH
COLOR / AUTOMATIC
and so on ...
If a colour video signal is displayed in colour, and the colour signal
changes from colour into black and white, the monitor goes into
COLOUR OFF / FULL BANDWIDTH mode, and selection is
possible between two modes :
COLOR OFF / FILTERED and
COLOR OFF / FULL BANDWIDTH
When colour returns, that mode is enabled which was selected at
the instant that colour felt away. Again there's choice between
three different colour modes.
When no colour is displayed, the green
LED
above the MONO key
lights up.
COMB
Key to enable or disable the comb filter, in case a
NTSC
decoder is
installed in the monitor.
When the comb filter is enabled, the green
LED
above the COMB
key lights up.
APT
Key to enable or disable aperture correction.
When aperture correction is enabled, the green
LED
above the APT
key lights up. The aperture correction is adjustable by means of a
potentiometer on the rear side of the monitor.
SIZE
Key for selection of picture size, between overscan and underscan.
DEL (DELAY)
Key to select between normal picture, horizontally delayed picture
or pulse cross. Starting from normal picture,
DEL
key presses give
you :
HORIZONTAL DELAY
VERTICAL DELAY
PULSE CROSS
NO DELAY (normal picture)
and so on ...
13