Barco CVM 2037, Инструкция по эксплуатации

Страница: 14 / 92

REMOTE 2
a
REMOTE 1
0
0
75
0
0
75
0
0
71 5 ..
0
75
AUDO
75
G
75
B
75
SYNC
LS
OUTSIDE TERMINALS & SWITCHES
(continued)
REMOTE 2 REMOTE 1
Female and male 9-pins receptacles for remote control. MMRC
and CVS compatible.
Permits different ways of remote control, using a :
SRC (Single Remote Controller) for full remote control of
one monitor via REMOTE 1 connector — available.
MMRC (Multi Monitor Remote Controller) for full remote
control of up to 48 CVS and/or CVM monitors — available.
- Your own remote control solution (RS232) — info available.
RIS (Remote Input Selector), limited to input selection and
function switching — not available. Refer to the description of
menu item 4 (Ris configuration) in this manual.
CHANNEL A CHANNEL B CHANNEL C SYNC
Looped through inputs for component signals (BNC type).
The input formats are noted on the rear side panel. See also the
Specification Section of this manual for more information.
Each input is provided with an internal 75 ohms termination resis-
tor. Set the 75 ohms switch in upward position for termination.
LS
Loudspeaker output (DIN type).
There are two ways to connect the external loudspeaker.
The first one is plugging the connector with its round pin upwards.
Then the internal loudspeaker is enabled and in parallel with the
external one.
The other way is plugging the connector with its round pin down-
wards. Then, the internal loudspeaker is switched off.
AUDIO
Audio input (XLR connector).
Pin 2 is input and pin 3 is ground.
Notethat the monitorcan have a digital input module instead of an
analog component one. More information on this module can be
found in the manual called CVM2037/2051 D1/D2 Serial/Parallel
Decoder.
8