Barco CVM 2037, Инструкция по эксплуатации

Страница: 19 / 92

INP1
INP3
-
DOWN
I
INP2
.1
.::::.
COMP INP
-..:
SYNC
' •
SL/F
UP
s. U
COMMAND KEYS (continued)
COMP INP (ANALOG COMPONENT OR DIGITAL INPUT)
Analog Component Input Module
Key for the selection of the signals applied to the component
inputs. The component input format can be programmed to one
of the three following ones: RGB , Y/R-Y/B-Y or S-VHS .
To program the component input format, pass via the KEY-
BOARD EXTENSION menu. Refer to the description of this
menu in this manual.
D1 /D2 Digital Input module
When this key is pressed the LED in this key is lit, and also one
LED in one of the keys for input selection to show the selected
digital input. To turn back to an analog composite input, press
again this key COMP IN.
To program the digital input format, pass via the KEYBOARD
EXTENSION menu. Refer to the description of this menu in this
manual.
SYNC
Key for the selection of internal or external synchronization. In case
of external sync, the input signal applied to
INPUT
3 is used as sync
reference.
When external sync is enabled, the green led above left of the
SYNC key lights up.
SL/F (SLOW / FAST)
Key for the selection of horizontal sync time constant.
If fast sync is enabled, the green led above left of the SL/F key
lights up.
This key is also used to go UP in the menu's.
INP1 INP2 INP3 (INPUT 1 INPUT 2 INPUT 3)
Keys for the selection of one of the standard available composite
inputs.
The selected input is identified by an enlighted green
LED
above the
corresponding command key.
If the monitor is set for external sync,
INPUT
3 can not be selected.
When a digital input board is installed, these keys are also for input
selection after the input COMP INP has been selected.
Key INP3 is also used to go DOWN into the menu's.
12