8
STEP 6 Connect the corrugated gas pipe
Side burner to barbeque
connecting corrugated pipe
Take out the tray
Disconnect the
gas tube cap
Connector the ripple
pipe to the barbecue.
Connecting The Gas
The side burner corrugated gas pipe will already
be connected to the side burner.You need to
connect the other end to the barbeque.
IMPORTANT:
Use a spanner to tighten
are caused by connections which are
only hand tightened. Before turnning
the gas on, refer to your barbeque
instructions for directions on leak test
and general gas safety.
a. Remove the grease channelling tray and use
two spanners to
disconnect the cap from the
manifold outlet (one spanner to hold manifold,
the other to
loosen the
cap)
b. Thread the corrugated pipe from the
side burner through the bbq as shown
c. Connect the corrugated pipe to the manifold,
using two spanners ( one spanner to hold the
manifold, the other to tighten the pipe fitting )
d. Adjust the corrugated hose so that it is neat
and out of the way.
Side Burner Trivet
Open the lid of the side burner. Push the longer
prongs of the trivet into the holes in the side burner
body. The trivet should sit securely in place without
moving.
