XIRING – Ingenico Healthcare / eID – Baracoda orKan ‘barcode’ – User Guide v1.5
24/35
-
to an application window: In this case always double-check that the cursor in your
text window is active before starting the upload procedure. Otherwise you will
loose all the data saved on your orKan terminal.
3)
Different Reading modes
The orKan terminal has four (4) reading modes. These modes can be set through either the
Baracoda Desktop Manager software or the Programming Guide.
a.
Trigger mode (default setting)
Simply press the middle trigger button when you want to capture data.
b.
Aiming mode mode
The Aiming mode has been developed for users who need to scan barcodes very close
one to another and need to avoid reading the wrong code. Once in this mode, in order
to read a barcode user will have to press the trigger twice. Pressing it the first time will
switch on the beam but not the decoder (thus allowing user to aim at the correct
barcode). Pressing the trigger the second time will activate the decoder thus allowing
the terminal to actually decode the barcode.
Nota : this feature is only available for orKan 1D & Laser – not for 2D imager
c.
AutoScan mode
This mode enables to scan continuously; in Autoscan mode the scan beam is
continuously on. This mode allows a very fast reading, but battery consumption is high.
d.
Manual AutoScan mode
When this capture mode is selected, pressing the trigger will switch ON the beam
continuously (like in Autoscan). The beam will stay in this mode until the trigger is
pressed again.
Note: in the case where the trigger is not pressed the second time (to stop the Manual
Autoscan) the beam will stay on until the shutdown timer expires. When the terminal is
switched ON, pressing the trigger will switch the beam on continuously.