10
S
B
I M P LY
E T T E R !
B K
&
ZONE VIDEO CONNECTIONS
Zone Video Outputs
The selected video in each zone is routed to the appropriate Zone A-F video out. Each of the HD6’s six zones
provide simultaneous video distribution for use with standard RCA cable and Category 5e (CAT5) cable. RCA
terminated video cable works best with distribution runs under
150 feet
. Category 5e cable allows differential
video runs of up to 1000 feet. The HD6 CAT5 video drive allows direct connection to B&K LB10W and LB20F
modules for use in converting the video signal back to RCA. The
LB10W
is for use with a decora wall mount
plate. The
LB20F
is a fully enclosed box for use where mounting in a wall plate is not possible. The diagram
below shows the HD6 connected using RCA termination in zones A-C, and CAT5 termination with
LB10W
CAT5
-> RCA local decora video conversion modules in zones D-F.
CAT5 Video Drive Pinout
CAT5 RJ-45 pinouts use the T568B standard. See the
figure at right. Each color twisted pair carries the differ-
ential video signal to the corresponding video output.
For use with Category 5e cable up to
500 feet
, Pin 7
and 8 will directly power a B&K LB10W or LB20F
module without the need for an external power supply.
Use of other CAT5 connection standards may result in
increased crosstalk between Y, Pr, Pb signals with
associated video degradation.
Note: DC power on Pin 7 and 8 is intended only for use
with a B&K LB10W or LB20F module.
HARDWARE CONNECTIONS
Typical CAT5 wire termination
CAT5 RJ-45 Video Pinout
