Bandit SG-40, Инструкция по эксплуатации и каталог запасных частей

Страница: 33 / 92

Bandit
31
MODEL SG-40 HYDRAULICS
Equipment
Model
SG-40
Track Drive
PSI (bar)
2950
(203)
Swing Setting - Right
PSI (bar)
1000
(68)
Swing Setting - Left
PSI (bar)
1200
(82)
Cutter Wheel Up / Down
PSI (bar)
1800
(124)
TYPICAL HYDRAULIC RELIEF
PRESSURE SETTINGS
(Approximate, For Reference Only,
Engine At Full RPM)
HYDRAULICS
Do not under any circumstances over-set these
relief pressures, it will cause damage to component
parts and hydraulic parts.
­ These­typical­hydraulic­flows­and­relief­pressure­
settings are with the engine at full RPM. All settings
are subject to change.
After the initial start-up of the machine and after
any­replacement­of­­hydraulic­components,­fittings­
and hoses must be re-checked for leaks and
clearances.
Insert Pressure
Check Gauge Here
Unhook this hose
and­plug­it­off
The relief valve is typically located internally in the
valve bank. Do not adjust the relief valves above the
­specified­psi­(bar).­The­relief­valve­system­is­a­simple­
spring tension design but small pieces of debris can
stick the valve partially open which weakens the
hydraulic power. The relief as well as hydraulic oil,
and suction screen must be kept clean.
CHECKING HYDRAULIC
PRESSURE
1. Make­sure­all­the­controls­are­in­the­off­position.
2. Install pressure gauge into the test port, see
below.
3. Start engine and adjust engine to full throttle.
4. Engage the control lever or switch so that the
cylinder of the function that needs to be checked,
bottoms out and then read the pressure gauge.
5. Adjust relief if necessary. Turn the relief clockwise
to increase pressure and counter- clockwise to
decrease the pressure.
Track
Relief
Cutter Head Swing Left/Right &
Cutter Head Up/Down Relief
1. Make­sure­all­the­controls­are­in­the­off­position.
2. Swing the console to the right side, and place a
drip pan below.
3. Unhook the Right Track B-Port hose and plug
it­off.
4. Install pressure gauge into the test port, see below.
5. Start engine and adjust engine to full throttle.
6. Engage the Right Track in the forward position
and read the pressure gauge.
7. Adjust relief if necessary. Turn the relief clockwise
to increase pressure and counter- clockwise to
decrease the pressure.
SWING LEFT/RIGHT &
CUTTER WHEEL UP/DOWN
PROCEDURE
RIGHT & LEFT TRACK
PROCEDURE
NOTICE