Bandit SG-40, Инструкция по эксплуатации и каталог запасных частей

Страница: 26 / 92

24 6/20
MAINTENANCE MODEL SG-40
CUTTER WHEEL
DO NOT operate machine without a full set of
teeth. Operating the machine without a full set of
teeth can cause excessive vibration and premature
bearing failure.
A locking pin is provided to hold the cutter wheel
in position during tooth removal and reinstallation.
Locking pin will only lock on outer teeth.
Use only original equipment manufacturer’s teeth.
The use of any other aftermarket teeth may cause
damage or premature failure to the drive train.
Before attempting any type of maintenance,
disengage clutch or cutter wheel engagement, wait
for the cutter wheel to come to a complete stop, turn
off­engine,­remove­the­ignition­key,­make­sure­the­
ignition key is in your possession, disconnect the
battery, and install the cutter wheel lock pin.
DO NOT go near the rotating cutter head for any
reason. DO NOT go near the cutter head while the
engine is running or the cutter head is coasting to a
stop. Contact with a rotating cutter head will result
in serious bodily injury or death.
Never use hand on cutter wheel to hold in place
while changing teeth. Be sure to remove locking pin
before operating the machine.
DO NOT operate machine with extremely worn or
broken teeth.
SAFETY INSTRUCTIONS
DANGER
NOTICE
Inspect pockets, teeth and bolts for damage and
replace as required.
When replacing pockets, always replace new
pockets across from each other (180°) in order to
prevent vibration.
Replacement teeth must be carbide tipped and of
like design as provided with the machine.
Use anti-seize on threads to help prevent bolts
from “freezing up” in cutter wheel pockets.
When replacing complete set of teeth, be sure to
duplicate original factory tooth arrangement, with the
carbide tip facing the cutter wheel rotation. Typically a
1/2” socket is required to change or torque the teeth.
See­page­20­for­torque­specifications.­
GREEN TEETH MAINTENANCE
See Page 40 for Cutter Wheel Setup & Part Numbers
When the tooth has 1/16” of wear on the carbide
tip, it is time to rotate or replace the tooth.