Bandit SG-40, Инструкция по эксплуатации и каталог запасных частей

Страница: 16 / 92

14 6/20
MACHINE OPERATION MODEL SG-40
MACHINE OPERATION
Do not start to grind a stump unless you are
completely sure there are not any utility lines in
the area above or below the ground level where
you are grinding. Always contact the utility locating
service in your area or local utility companies to mark
underground utility lines.
Keep clear of cutting wheel, moving machine parts
and­grinder­debris­field.
Wear all personal protective equipment per ANSI,
OSHA and manuals.
The stump must be cut as low to the ground as
possible to reduce the amount of grinding material,
debris,­and­lessen­the­chance­of­flying­debris­in­the­
work area.
1. Before­ starting­ the­ machine­ check­ all­ fluids,­
and follow all daily maintenance procedures.
2. Make sure the lock pin is not in the frame lock
hole or the cutter wheel lock hole.
3. Start the engine.
4. Test the following controls to make sure they
function properly.
a. Swing Left/Right
b. Cutter Wheel Up/Down
c. Travel Forward/Reverse
5. Make sure the machine is at low idle.
6. Engage the cutter wheel.
7. Throttle the machine up to ensure the cutter
wheel rotates properly (if the cutter wheel does
not rotate properly shut the machine down and
diagnose the issue).
8. Throttle the machine down.
9. Disengage the cutter wheel.
10. Throttle the machine up.
11.
Move­the­machine­to­the­first­stump.
12. Raise the cutter wheel above the stump.
13. Swing the cutter wheel all the way to the left and
to the right to ensure there are no obstructions.
14. Make sure the cutter wheel is positioned on the
right side of the stump.
15. Throttle the machine down.
16. Engage the cutter wheel.
17. Throttle the machine up.
18. Lower the cutter wheel to the stump and make
a few light passes at the stump to get a feel for
the cutting action.
19. Gradually increase the cutting action and
work away at the stump by swinging the cutter
wheel left-to-right-to-left through the stump in a
side-to-side motion. The cutting actions should
be­smooth­and­effortless.­If­it­is­not­either­back­
the machine up or lift the cutter wheel up to take
a smaller bite.
20. Continue cutting the stump by adjusting the
cutter wheel progressively lower until the stump
is cut well below ground level.
21. Raise the cutter wheel above the ground.
22. Swing the cutter wheel back to the right side of
the stump.
23. Move the machine closer to the stump for the
next series of passes and continue cutting.
24. Repeat steps 19 through 23 until the stump has
been fully removed.
25. If working with a large stump, you may need to
reposition the machine in order to fully remove
the stump.
26. Repeat steps 8 through 25 until all required
stumps are removed.
27. When all stumps are removed, return the cutter
wheel to the center position
28. Insert the lock pin in the frame lock hole.
29. Load the machine according to the instructions
in the Transportation Procedures.
DANGER
WARNING
NOTICE
DO NOT operate machine without a full set of
teeth. Operating the machine without a full set of
teeth can cause excessive vibration and premature
bearing failure.
Use only original equipment manufacturer’s teeth.
The use of any other aftermarket teeth may cause
damage or premature failure to the drive train.
DO NOT operate machine with extremely worn or
broken teeth.