14. Auto-Close
WARNING! It is compulsory to have
Safety Beams installed when using
Auto-Close mode.
Auto-Close mode is a function that automatically closes the
door after a pre-set time. Safety beams must be installed in
order to run the Auto-Close function. There are two types of
Auto-Close available:
i. Standard auto-close - the door will Auto-Close after
a programmed time. In this mode the timer starts to
countdown as soon as the door is fully open. This function
is useful in case the safety beam does not get triggered.
ii. Safety Beam triggered auto-close - the door will auto-
close after a programmed time. In this mode the timer
starts counting down only when the safety beam is
triggered. ie car leaving the garage.
To enable the Auto-Close function:
a. Press the MODE button repetitively until the GEAR
LED
starts flashing.
b. Press the OPEN button
until the GEAR
LED flashes:
i. two (2) times to get to PE auto-close or
ii. three (3) times to get to standard auto-close.
c. Press STOP / SET button to enter parameter.
d. The default setting for Auto-Close is OFF. Press the OPEN button
to move through options and the light’s brightness will
change accordingly.
e. Press STOP / SET button to save the parameter’s new value or
press MODE to leave the value unchanged.
Parameter
Value options = Indicated by brightness of
main light (DEFAULT parameter underlined)
Name
Flashes
1
2
3
4
5
6
PE AUTO-CLOSE
2
OFF
15sec
30sec
60sec
90sec
-
AUTO-CLOSE
3
OFF
15sec
30sec
60sec
90sec
120sec
11
Controll-A-Door
®
-
Installation instructions
