Baldan MOVERE, Инструкция по эксплуатации

Страница: 50 / 86

DISK HARROWS LEVELING - PART II
ƒ
Levelling
6
5
10 MM
06 - REAR POSITION:
When MOVERE is in this position, lower
it by first lowering the hydraulic system.
Then tighten the nuts and locknuts (5)
of the head mounts (6) every 10 mm.
Then, operate the hydraulic system to
raise MOVERE and check its position. If
you still need to adjust it, re-tighten it
by tightening the nuts and bolts (5) + 10
mm and then lift it and check again.
Repeat this procedure until MOVERE
stays level.
When MOVERE is in this position, first lower it by
lowering the hydraulic system. Then, loosen the upper
nuts (7) of the center rods (8) every 10 mm. Then
tighten the lower nuts (9) until it touches the face of
the bushing (10). Then, operate the hydraulic system to
raise MOVERE and check its position. If you still have to
adjust it, lower it again by releasing the upper nuts (7) +
10 mm and then lift it and check again. Repeat this
procedure until MOVERE stays level.
07 - FRONT POSITION:
MOVERE IN A LEVELED POSITION
The measures mentioned in the leveling are initial parameters for
the leveling of MOVERE,
WARNING
7
9
8
7
10
9
8
Instruction Manual
MOVERE
50