Baldan CRI, Инструкция по эксплуатации

Страница: 30 / 68


After assembling the hydraulic cylinder, secure the coupling head, proceeding as
follows:
01 - Insert the rod (1) into the upright (2).
02 - Then attach the coupling crossbar (3) to the upright (2) and between both, fit wear
washers (4), securing the set with bolts (5), pressure washers (6) and nuts (7).
03 - Then secure the rod (1) to the crossbar (3) through pin (8) flat washer (9), cotter pin
(10) and fit stop bushing (11), spring (12), stop bushing (13), nut and lock nut (14).
04 - Finish by attaching the stabilizer bar bracket (15) to the coupling head (16) through
bolt (17), washer (18) and nut (19).
3
7
6
4
4
4
4
5
2
10
8
11
1
15
19
18
17
16
14
13
12
9
Always install washers (3) between two washers (2) when
assembling the crossbar (4) onto the upright (2), as these washers
prevent friction between the upright (2) and the crossbar (3).
ATTENTION
When checking friction between the
upright (2) and the crossbar (3),
immediately replace
wear washers (4).
IMPORTANT
Instruction Manual