Baldan CRI, Инструкция по эксплуатации

Страница: 33 / 68

Instruction Manual
CRI 12-30 33
After engaging the CRI to the tractor,
REMOVE pin (1) from hole “A”. Do not
transport or work the harrow without
first removing the pin (1) from the
header. Ignoring this warning may
damage the CRI. For easy removal of
the pin (1), operate the tire lowering
control.
ATTENTION
01 - Slowly approach the tractor in the reverse gear, paying attention to the application of the
brakes. Then, turn off the tractor engine, relieve the pressure of the control by pushing the
lever a few times and check that the couplings are clean if you are not cleaning them.
02 - Then start the engine by lowering the CRI tires until the pin (1), flat washer (2) and lock (3) are in
the “A” hole.
03 - Then start the engine by lifting the CRI tire until the shackle ( 4 ) is at the height of the tractor
bar.
04 - Then engage the
CRI
to the tractor by attaching the locking pin ( 5 ), plain washer ( 6 ) and
ring lock ( 7 ).
05 - Finish by attaching the hydraulic hoses ( 8 ) to the tractor quick coupling.
To couple the CRI , proceed as follows:
• Harrow coupling in the traction bar of the tractor
ƒ
Hitch
Never disengage the hydraulic hoses without first
lowering the CRI and relieving the control pressure.
IMPORTANT
When engaging the CRI, look for a safe and easily accessible
place. Always use low gear with low acceleration.
OBSERVATION
6
5
2
1
3
7
4
8
“A”