INSTALLATION
SETUP/PHYSICAL INSTALLATION
3 - 2
I-E96-209A
®
SETUP/PHYSICAL INSTALLATION
NOTE: The Installation section provides instructions pertaining to
the installation of the LMM only. For complete TU/TM installation,
wiring and cable information, refer to the
This section explains the procedures to set switches and jump-
ers, and install the LMM. After installing this module, a config-
uration must be created to define the functions an LMM will
perform.
NOTE: The slave expander bus must be connected between the
LMM and associated slave modules before they can communicate;
refer to
in this section.
Logic Master Module Installation
1. Setting the address and hardware operating mode on the
Module Address Switch (S2).
2. Setting the digital input jumpers for the type of digital
input.
3. Connecting cables.
4. Installing the module.
Figure
shows the location of the hardware configuration
switch and edge connectors.
Figure 3-1. Logic Master Module
MODULE ADDRESS
SWITCH (S2)
MODULE
STATUS LED
MODULE RESET
SWITCH
DIGITAL INPUT
JUMPERS
GROUP A
OUTPUT
LEDs
GROUP B
INPUT
LEDs
P1
P3
P2
TP21032A
