Bad Boy Outlaw 6100, Руководство владельца, обслуживания и запасных частей

Страница: 19 / 80

SERVICE SECTION
SECTION 1: HYDROSTATIC SYSTEM
PAGE
19
The hydro reservoir tank on the Outlaw model is located
on each side of rear cover. Notice the “full cold” line at
the bottom of the tank. Use only 20W-50 motor oil in this
tank. Conventional or synthetic
oil may be used.
THE FOLLOWING MAINTENACE IS TO BE
PERFORMED ON A LEVEL
SURFACE.
Outlaw transaxles hold 4 quarts of 20W-50 moto oil each.
Bad Boy Hydrostatic Oil is recommended. Transaxle
service is recommended after the first 75 hours of use;
then at intervals of 250 usage
hours. Use only Hydro-Gear ® brand oil filters. Use
of other brands could void the warranty.
Changing your hydraulic oil and filter
Outlaw 4400
1)
Place an oil drain pan (12” or more in
diameter and 8 qt. capacity is optimal)
beneath the oil filter. Remove the oil
filter cover from the transaxle to drain
the oil. Remove the O-ring from the
cover and discard the O-ring.
2)
After the oil has drained from the transaxle,
remove the oil
filter from the transaxle
housing.
3)
Install a new filter and a new O-ring onto the
filter cover and
install the filter cover. Torque
the filter cover to 200-300
in-lbs.
4)
Fill the transaxle with new 20W-50 motor oil
through the
hydraulic reservoir until it
reaches the cold fill line on the tank.
5)
Drain the old oil filter of all free flowing oil
prior to disposal.
Place used oil in
appropriate containers and deliver to an
approved recycling collection facility.
6)
Proceed to the purge procedure on the next
page.