Bacsa BLP-545, Руководство пользователя

Страница: 8 / 71

USER’S MANUAL
2
1.2 INSTALLING THE LP-2550 LABELLER
Follow the instructions below to ensure correct installation and operation of the labellers.
1. Check that the mains voltage corresponds to that stated on the specifications label on the labellers and
that it does not fluctuate in excess of 10% of nominal voltage.
2. Make sure that the labellers can be connected to a nearby socket that is easy to access. We
recommend that the socket should be provided with differential breaker, thermal-magnetic trips, and
earth.
3. Make sure that other equipment such as refrigerators, cutting machines, etc. are not connected to same
socket.
4. Only use the labellers in areas that comply with the room temperature values stated on the
specifications label (-10ºC to 40ºC).
5. Peripheral devices connected to the equipment must be protected against fluctuation peaks of
above 8A 100VA.
6. The labellers must be placed on a stable, level surface.
7. No objects must come into contact with the dish.
8. Avoid extreme temperatures. Do not place the labellers in direct sunlight or close to air
conditioning vents.
10. These labellers have not been designed as waterproof labellers. Therefore, avoid high levels of
humidity since this might cause condensation. Protect from rain and avoid direct contact with
water. Do not spray water on the labellers or submerge in water. If the labellers get wet, switch off
the power supply immediately.
1.3 ADVICE FOR MAINTENANCE AND CARE OF THE LP-2550 LABELLER
By following these recommendations, your labellers will remain in perfect working order, thus obtaining a
better performance and a longer life.
1. Never place a weight on the labellers that exceeds the maximum limit.
2. Do not place weights suddenly on the dish if they exceed a sixth of the maximum limit.
3. Do not exert sideways pressure on the dish
4. Always keep the keypad and dish clean. Use a dry cloth (and a suitable cleaning product) to clean
the labellers.
5. Never pour or spray water on the labellers. If the labellers get wet, switch off the power supply
immediately.
6. Do not move the printer when it is switched on.
7. Do not modify the labellers’ mechanical or electrical characteristics.
8. Clean the thermal head with the labellers switched off. Do not use blades or sharp objects for this
purpose.
9. Only have the labellers repaired by authorised persons, with suitable training.
10. Always use original parts.
11. It is recommended to keep the labellers out of direct sunlight, protected from rain; avoid
excessively humid conditions.
The labellers leave the factory prepared for retail sales. Therefore, labels can be printed at below the minimum limit.
In the case of pre-packaging activities, in accordance with legislation in force (Standard EN 45501 and Directive 90/384/EC), this type
of equipment may only be used if packages are above the minimum limit.
The labellers can be set up for specific use for pre-packaging tasks. Consult your supplier or technical assistance service.