![background image](http://html1.mh-extra.com/html/backyard-discovery/oxford-6111/oxford-6111_owners-manual_3386775053.webp)
Phase Notes
• Assemble with hardware as shown.
Fort Assembly
Phase 4
Step 1: Attach 'L3' Outer Floor Boards
to 'J1' floor supports, 'H1' & 'H5' floor
board supports & 'H3' floor joists using
Screws 'BS', as shown.
Parts needed:
• (2) L1 - OUTER FLOOR BOARD - W101639
• (2) L3 - OUTER FLOOR BOARD - W101637
• (11) M1 - FLOOR BOARD - W101611
Hardware needed:
• (120) BS - SCREW PFH 8x1-3/4 - H100089
BS
H1
H2
L3
M1
BS
BS
E5
E3
BS
BS
BS
H1
H2
H5
L1
L3
L1
Note: It is vital that the fort
be level before and after
each phase of assembly.
To prevent board splitting, you
must pre-drill each board with
a 1/8" drill bit, before attaching.
Step 2: Attach 'L1' Outer Floor Boards
to 'E11' fort braces, 'H1' & 'H5' floor
board supports & 'H3' floor joists using
Screws 'BS', as shown.
E11
E11
Step 3: Attach 'M1' Floor Boards to 'H2',
'H1' & 'H5' floor board supports & 'H3'
floor joists using Screws 'BS', as shown.
Note: Do not overtighten screws, overtightening
may cause the screw to stick through the boards
and may cause sharp points. The head of the
screw should NOT sink into the wood for this
phase, it should be flush.
Note: Due to the changing size of the wood
as a result of moisture content, you may
need to adjust the spacing of your wall slats
1/16" to 1/8" when assembling walls. It would
be best to line up the boards on the wall
before attaching to estimate if a larger or
smaller gap is needed.