Bacci Twin, Инструкция по эксплуатации и обслуживанию

Страница: 52 / 202

TWIN
– Use and maintenance instruction manual
Chap. 2
-
34
/
52 -
2.15 Safety regulations for pneumatic maintenance
•
Maintenance may be carried out only by qualified technicians. Before starting any type of
maintenance, place a “MAINTENANCE UNDERWAY” warning sign on the machine, stop the
machine and cut-off all electrical and pneumatic sources. For this purpose, close the main
pneumatic supply valve (
1 ), then turn off the main switch ( 2 ) and adopt all the measures required
to avoid start-up.
•
To carry out maintenance on the pneumatic system, first release the pressure using the
pneumatic EMERGENCY STOP switch ( 1 ) and releasing all residual compressed air.
•
Use appropriate tools and equipment for proper disassembly and re-assembly.
•
Use only appropriate hoisting equipment. Before hoisting the unit, check the weight, barycenter,
and location of the anchor points. Please consult the specific instructions contained in the
Installation chapter.
•
Before starting the system, check for defects.
•
Make sure that the machine safety devices are present and functioning. Do not remove safety
devices or other safety equipment. If safety devices must be dismantled, for example for
maintenance or repair work, they must be replaced immediately upon completion of the work and
tested for proper functioning.
•
Follow current safety regulations when handling oils, greases and other chemical substances.
2.16 Residual risks
The machine is manufactured and protected so as to provide for maximum safety only when used in
compliance with the specifications for use. The machine is equipped with safety devices to safeguard
operating personnel.
Some risks cannot be fully eliminated. Personnel are therefore exposed to some residual risks. Such
risks are specified and described following, along with possible causes and the precautions to be taken
to avoid them.
1
2
1