45
46
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
7.0
Toddler Car Seat (With Built-in
Harness) Installation and Use
8. Pull to check that the vehicle buckle
is securely locked.
NOTE: If Lap belt is not long enough
and LATCH system is not
available, install Car Seat using
“REAR ENTRY” belt path, (see
“Installation - Lap Belt Only
WITHOUT
Top Tether” section).
9. Place knee inside seat and while pressing
down
(1)
, pull on the free end of the vehicle
lap belt
(2)
to tighten the lap belt around
the car seat.
10. Attach Top Tether Hook to vehicle tether
anchor
(1)
and
(2)
. Listen for the “click”
when the tether hook locks onto the
vehicle tether anchor.
11. Pull on the Top Tether Strap to check that
the Tether Hook is securely attached
(3)
.
12. Pull on free end of Top Tether Strap
until all slack is removed from the
Top Tether
(4)
.
3. Adjust the harness strap height for
your child – Harness straps MUST
be at or above the child’s shoulders
(see “Changing Harness Strap
Height” section).
4. Place Top Tether over the top of the
Head Support and rest inside seat.
5. Place the car seat on the vehicle seat in
a seating location equipped with Lap belt
and centered between the Lap belt
anchorages (see “Selecting a Vehicle
Seating Location” section).
6. If the vehicle seat back is adjustable,
adjust into the upright position or the
position specified in the vehicle owner’s
manual for use with a car seat.
7. Pull the vehicle Lap belt out and route
through the car seat using the “FRONT
ENTRY” belt routing as shown in Section
7.3.1 and buckle the vehicle seat belt.
- Route Vehicle Lap Belt over top of the
Harness Straps so that Harness Straps
are routed between back of Back
Support and vehicle belt.
Top
Tether
FRONT
ENTRY
Belt
Routing
2
1
1
2
4
3
Top Tether
Route LATCH or vehicle seat
belt over top of Harness Straps
