33
34
Copyright © 2016, Baby Trend, Inc.
Copyright © 2016, Baby Trend, Inc.
5.0 Installation and Use
5.0 Installation and Use
6. Lower flap and secure hook and loop fasteners.
7. Attach Top Tether to a designated anchor point.
Pull Top Tether strap until webbing strap is snug.
NOTE: Your automobile’s owner’s manual will
give the anchor locations and maximum weight of
the restraint’s occupant for LATCH connections.
8. Check for movement of the restraint at the safety
belt path. The restraint should not move more
than 1 inch in any direction. If the restraint moves
more than 1 inch repeat all steps until all safety
steps are met.
5.8 LATCH Connector Belt Rerouting
Reroute From Forward Facing Belt Path to Rear Facing Belt Path:
The correct belt path must be used for proper installation.
1. Unthread LATCH belt out of the front facing
safety belt path (Fig. 33a).
2. Unsnap the 2 front snaps and the 2 side
snaps. Lift and fold back padding (Fig. 33b).
3. Route LATCH belt through the rear facing
safety belt path (Fig. 34a) leaving the
adjuster side of the LATCH belt on the
child’s LEFT side (Fig. 34b).
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing
the restraint to the vehicle.
4. Lower flap and secure hook and loop
fasteners and all snaps (Fig. 34c).
Reroute From Rear Facing Belt Path
to Front Facing Belt Path:
1. Unthread LATCH belt out of the rear facing
safety belt path (Fig. 34d).
Rear of Vehicle
Fig. 34a
Fig. 33a
Fig. 33b
Fig. 34b
Fig. 34c
Fig. 34d