21
22
Copyright © 2016, Baby Trend, Inc.
Copyright © 2016, Baby Trend, Inc.
5.0 Installation and Use
5.0 Installation and Use
Rear Facing Installation with Lap Belt. With Headrest.
Requirements. See section 2.2:
Weight is between 5 and 40 lbs (2.3 kg and 18.1 kg),
and head is 1 inch below the top of the seat.
1. Squeeze recline handle and recline the seat to
positions 1, 2, or 3. Angling the seat will keep the
baby’s head back and airway open.
Note: If needed
a rolled up towel or pool noodle can be used for
extra elevation and angle adjustment.
2. Place this restraint in a rear seating position and ensure vehicle is level.
3. Unsnap the 2 front snaps and the 2 side
snaps. Lift and fold back padding.
4. Route lap/shoulder belt through the rear
facing safety belt path (Fig. 22a).
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing the
restraint to the vehicle.
5. Put weight in seat with hand to compress the
automobile seat cushion then insert the seat
buckle tongue into the buckle and pull seat
belt tight as possible (Fig. 22b). Pull up on
buckle as to ensure the buckle is secure.
6. Lower flap and secure hook and loop
fasteners and all snaps (Fig. 22c).
7. Ensure the rear facing angle indicator
bubble is located between the boundary
lines (Fig. 22d).
8. Check for movement of the restraint at the
safety belt path. The restraint should not
move more than 1 inch in any direction. If the
restraint moves more than 1 inch, repeat all
steps until all safety steps are met.
Rear of Vehicle
With headrest
Fig. 22a
Fig. 22b
Fig. 22c
Fig. 22d