Baby Lock Regalia BLPS4-RG, Руководство по началу работы

Страница: 12 / 26

12 | Getting Started www.BabyLock.com
Lip
3. Use the carriage as a guide and align the blue
Flexirack with the white gear along the length of
the table (see arrow at right), removing the pink
protective layer and pressing downward on the
blue Flexirack while moving the carriage down the
entire length of the table.
4. Double check the alignment of the carriage white gear with the blue Flexirack by rolling the carriage
along the entire length of the table.
5. Trim the Flexirack to length using a knife or wire
cutters. The blue Flexirack does not need to
extend the full width of the table and can be a
couple of inches shorter on both ends.
6. At both ends of the blue Flexirack, use two of the
small metal clamps
(see Parts List, item C)
to hold
the ends firmly in place. The clamps have a hole
through the center and a lip on one end. The lip
should be on the side opposite the blue Flexirack.
Place the clamps where they will be attached
and drill pilot holes using the 3/32-inch drill bit
and then use a Phillips screwdriver to fasten the
clamps on both sides of the Flexirack to the table.