Baby Lock Regalia BLPS4-RG, Руководство по началу работы

Страница: 13 / 26

www.BabyLock.com Getting Started | 13
NOTE : As an alternative, use one clamp at each end. Slide the lip of the clamp over the last gear of
the blue Flexirack, drill a pilot hole, and screw in place.
To Install the Y-Rack
1.
Carefully lay the quilting machine on its left side (looking from the front). Pay close attention to the
Y-encoder mounted to the rear left wheel so you do not damage the Y-encoder bracket.
There is a hole underneath each base plate, near the wheels on the front tension assembly side of the
machine (the side with the thread tensioner and guides).
2. Attach the Y-Rack to the bottom of the front and
rear base plates with the two 10-24 x 1/2 inch
long screws and washers
(see Parts List, item H)
.
The blue Flexirack should be toward the middle of
the machine while the bolt holes should be toward
the outside. Use a 4mm Allen wrench to tighten
the screws in the center of the slotted Y-rack
holes. The rack will be adjusted later to align the
blue Flexirack with the Y-axis white gear.