Baby Lock BLTA, Инструкция и справочник

Страница: 39 / 204

WINDING/INSTALLING THE BOBBIN
G
etting
Re
ad
y
37
1
e
With your right hand, hold the thread near the thread
spool. With your left hand, hold the end of the thread,
and use both hands to pass the thread through the
thread guide.
1
Thread guide
f
Pass the thread around the pretension disk making sure
that the thread is under the pretension disk.
1
Pretension disk

Make sure that the thread passes under the
pretension disk.
2
Pretension disk
3
Pull it in as far as possible.
g
Wind the thread clockwise around the bobbin 5 or 6
times, pass the thread through the guide slit in the
bobbin winder seat, and then pull the thread to cut it.
1
Guide slit in bobbin winder seat
(with built-in cutter)
Memo
• When using the spool as shown below, use the
small spool cap, and leave a small space between
the cap and the spool.
• When using thread that winds off quickly, such as
transparent nylon thread or metallic thread, place
the spool net over the spool before placing the
spool of thread onto the spool pin.
If the spool net is too long, fold it to fit the size of
the spool.
When threading the spool with the spool net on,
make sure that about 5 cm (2 inches) of thread is
pulled out. It may be necessary to adjust the thread
tension when using the spool net.
• If a spool of thread whose core is 1.2 cm (approx.
1/2 inch) in diameter and 7.5 cm (approx. 3 inches)
high is inserted onto the spool pin, use the thread
spool insert (mini king thread spool).
1
Spool cap (small)
2
Spool (cross-wound
thread)
3
Space
2
1
3
1
Thread spool insert
(mini king thread
spool)
2
1.2 cm (approx. 1/2
inch)
3
7.5 cm (approx. 3
inches)
2 1
3
a
Note
• Be sure to wind the thread clockwise around the
bobbin, otherwise the thread may become
wrapped around the bobbin winder shaft.
CAUTION
• Be sure to cut the thread as described. If the
bobbin is wound without cutting the thread
using the cutter built into the guide slit in the
bobbin winder seat, the thread may become
tangled in the bobbin or the needle may bend
or break when the bobbin thread starts to run
out.
a
b c
a