Baby Lock BLTA, Инструкция и справочник, Страница: 46 / 204

UPPER THREADING
44
n
Carefully pull the end of the thread that was passed
through the eye of the needle.
* If a loop was formed in the thread passed through
the eye of the needle, carefully pull on the loop of
thread through to the back of the needle.
o
Raise the presser foot lever and pull out about 10 cm (4
inches) of the thread, and then pass it under the presser
foot toward the rear of the machine.
1
About 10 cm (4 inches)
Using the Twin Needle Mode
The twin needle can only be used for stitch patterns that
show after being selected. Before you select a stitch
pattern, make sure the stitch can be sewn in the twin
needle mode (refer to the “STITCH SETTING CHART”
on page 190).
a
Press to lock all keys and buttons and then
install the twin needle (“CHANGING THE NEEDLE” on
page 47).
b
Thread the machine for the first needle according to
the procedure for threading a single needle (“Upper
Threading” on page 42).
c
Pass the thread through the needle bar thread guides
on the needle bar, then thread the needle on the left
side manually.
1
Needle bar thread guide
Memo
• If the needle could not be threaded or the thread
was not passed through the needle bar thread
guides, perform the procedure again starting from
step
c
.
Then, pass the thread through the eye of the
needle after step
i
.
a
CAUTION
• Only use a genuine Tacony twin needle.
• When using the twin needle, it is
recommended to use presser foot “J”.
Note
• (Automatic threading button) cannot be used.
Manually thread the twin needle from front to back.
Using (Automatic threading button) may result
in damage to the machine.
a