B-TEK Scales WorldWEIGH C200 Series, Руководство пользователя

Страница: 6 / 20

C200 series bench scales service manual
- 2 -
SECTION 2. UNPACKING & INSTALLATION
2. 1. Unpacking
Unpack the container carefully. Examine the packaging and the device for any
damage, and report it to the shipper if there is any. Try to keep the scale upright.
Check for enclosures as follows:
 Scale platform
 Stainless steel pan
 Weighing indicator
 AC Adapter
 Operation manual

Ni-MH battery (optional)
Note :
1. If any items are missing or any damage is discovered immediately notify
your place of purchase or a dealer.
2. Keep box and shock absorber pad after installation. They are required for
transportation.
3. Battery must be charged for 24 hr prior till first use.
2. 2 Installing the scale
The pillar is attached to the base using a bracket that must first be attached to the
base frame using the 4 bolts supplied. The Pillar is secured to the bracket using 2
set screws. The cable from the base to the indicator module is run through the
tube, out through the plastic support at the top. Excess cable can be stored within
the tube.
The C200 Series comes with a stainless steel platform packed separately. Place the
platform in the base.
Attach the indicator module to the pillar by sliding it over the bracket with the flanges
engaged in the groves on the base. Attach the cable from the base to the
connector on the rear of the indicator.
2. 3 To Level the Scale
Level the scale by adjusting the four feet. The scale should be adjusted such that
the bubble in the spirit level is in the center of the level and the scale is supported
by all four feet. If the scale rocks readjust the feet.
The scale must be level for proper operation. Use the 4 level adjusters located at
the 4 corners of the scale main unit to adjust the horizontal position of the scale
until the bubble of the bubble level lies within the red circle. Ensure that the
scale sits solidly and does not wobble due to uneven adjustment.