RFM-C2 WMBUS – GPRS/Ethernet Gateway User Manual – Manuale d’Uso v1.1
pag. 15
3.2 LED Indicator
Here the variable statuses of the wireless interface state indicating LEDs are
described. The first LED from the right (when viewed from the front, see the figure
below) indicates the GSM module state. The function of this LED is to signal
terminal connection to the GPRS network and RFM-C2 Server in the TCP client
mode.
3.2 Indicatore LED
Qui di seguito vengono descritti gli status variabili dei LED indicanti lo stato delle
interfacce wireless. Il primo LED da destra (se visto da davanti, vedere immagine di
seguito) indica lo stato del modulo GSM. Questo LED può avere ha la funzione di
segnalare la connessione del dispositivo alla rete GPRS e la comunicazione col
server in modalità TCP client.
Front Panel with LED Indicators
Pannello frontale con indicatori LED
1.
NO LIGHT – POWER OFF – indicates that the 12V GPRS module power supply
is disconnected or has a malfunction or that the fuse is defective.
2.
THREE QUICK FLASHES – START or RESTART – indicates the device
start/restart. This state must always be indicated upon power supply
connection.
3.
SLOW FLASHING – INITIALISATION – indicates that the module is being
connected to the provider, IP network and RFM-C2 Server. If this happens
when the ETH activity is being monitored, the network is unavailable. The link
is missing, the cable is disconnected or interrupted between the device and
the nearest switch.
4.
VERY QUICK FLASHING – ERROR - indicates an error state: wrong PIN, no SIM
card, etc.
5.
ILLUMINATED – OK – RFM-C2 is connected to the provider, IP address is
1.
LED spento – DISPOSITIVO SPENTO – indica che l’alimentazione 12V è
scollegata oppure presenta malfunzionamenti o un fusibile è difettoso.
2.
TRE LAMPEGGI VELOCI – ACCENSIONE o RIAVVIO – indica l’avvio/riavvio del
dispositivo. Questo stato deve sempre indicato a seguito del collegamento
dell’alimentazione.
3.
LAMPEGGI LENTI – INIZIALIZZAZIONE – Indica che il modulo si sta connettendo
al provider, al server RFM-C2 e sta ottenendo l’IP. Se ciò accade quando
l’attività Ehternet è monitorata, la rete non è disponibile. Il collegamento
potrebbe essere assente, il cavo disconnesso o interrotto tra il dispositivo e lo
switch più vicino.
4.
LAMPEGGI MOLTO VELOCI – ERRORE – indica un errore nello stato: errato PIN,
nessun SIM card ecc.
5.
ACCESO – OK – L’RFM-C2 si è collegato al provider, l’indirizzo IP è stato