2ª 10028 – E 03 - 2016
13
H1. Clip
H2. Sugar and stirrer motor extractor
H3. Cup motor extractor
H4. Cup holder motor
H5. Cup support arm
H6. Cup support motor
H7. Electronic circuit board
H8. Cup extractor switch
H9. Cup detection photo-cells
H10. Hopper position microswitch
H11. Connector for the sugar and stirrer
cable
Characteristics of the cup extractor:
Range - ESP and INS
Units
700
Ø of the cups
From 70 to 71 mm.
Motor voltage
24 Vdc.
There is an extractor available for cups with a diameter of 73 mm.
The cup hopper is divided into 5 separate columns. When one of the columns is
empty, the motor spins the hopper so that another column of cups is situated over
the extractor. If, after 65 seconds of the motor running, the photo cells do not
detect a new column with cups, the machine goes to "out of order" status and the
display shows the message of "Out of order, no cups".
The cup hopper has a switch that can be pressed to manually extract a cup.
The electrical connexions of the terminals of the infrared photocells that are used to
detect the presence of the cups are:
