Page 8
1
2
3
• Using the marks on the
Anchor Posts, drill a
through hole only in the
Post Sleeve with a 1/4”
drill bit.
PRE-DRILL ANCHOR
POST SLEEVE
DRIVE IN HANGER
BOLTS
• On Anchor Posts, screw
the Hanger Bolts into the
pilot holes in the Post
with the Hanger Bolt
Installation Tool.
Leave about 1” of machine thread
exposed for cable take-up.
• For the through posts,
drill a 1/4” hole through
both the Post and Post
Sleeve.
PRE-DRILL
THROUGH POST
SLEEVES
Optional - Protector Sleeves are not
required on the through posts, but do
offer a more finished appearance.
If needed, use a dab of adhesive on
Protector Sleeves.
Anchor posts should not exceed 60 feet
apart during any continuous run of cable.
Pre-Drill 1/8”
into 4”x4”
Drill through
Post Sleeve
with 1/4” bit
1/4”
1/8”
Protective
Sleeve 1
Protective
Sleeve 2
1/4”
1/4”
Drill through
Post Sleeve
with 1/4” bit
Drill through
Post Sleeve
with 1/4” bit
1”
Installing CableRail by Feeney
®
for Evolutions Rail
TM
Contemporary
