20
CAR LIMIT SWITCH
Mount mechanical limit switch with roller by using supplied
metal bracket onto the cartop.
Connect its cable to X-KLSK socket to PWH board in
inspection box.
Move the car to downwards with inspection or recall
command to the position where the car is just below the
shaft limit.
Place and fix the lower shaft limit cam there.
Move the car to upwards with inspection or recall command
to the position where the car is just above the shaft limit.
Place and fix the upper car limit cam there.
INSTALLATION OF FLOOR SELECTOR AND ADJUSTING FLOORS
After selecting the floor selector system that you are going to
use in parameter A05 go to the document in Appendix-1
about floor selector installation.
Installing shaft switches, teaching floor levels and fine floor
adjustments is explained in this manual.
CLEARING PERMANENT ERRORS
Some critical errors, mainly UCM (unintended car motion)
error block the lift and do not allow further operation.
These errors are even not cleared when the system is
switched off.
The only way to get rid of them is using a special error
clearing section.
Go to SERVICES icon and then select line R01-UCM-CLEAR
ERROR in services menu.
TESTING SAFETY FUNCTIONS
There are a number of test routines implemented in
software.
They can be started in SERVICES menu.
SHAFT LIMIT TEST
The performance of the shaft limit switches can be tested by
using this test. See section 10.2 in device user manual for
detailed explanation of this test.
MANUAL UCM TEST
This test has been implemented to simulate an unintended
car motion situation and see the response of the system. See
section 7.4 in device user manual for detailed explanation of
this test.
