4-12
Care and Maintenance
Winterization Re-Commission
• Remove boat cover or shrink-wrap from boat.
• Remove Duct tape from exhaust flaps.
• Charge and install battery in boat. Follow all safety precautions associated with
changing batteries.
• De-winterize engine using engine manufacturer’s specifications.
• Check propeller shaft alignment. Tighten coupling hardware.
• Check engine compartment for nesting animals. Clean as needed.
• Reinstall seat cushions from storage.
• Check entire engine for signs of cracks caused by freeze damage. Check all hose
clamps for tightness. Install bilge drain plugs: transom, T-handle plug and ski
locker drain plug.
• Reinstall propeller assembly.
• If not performed during winterization, perform annual maintenance at this time.
• If boat is equipped with optional fresh-water cooling, and was drained at
winterization, fill at this time.
• With the boat in the water or using a flush kit, turn key on and off 2-3 times to
allow fuel to return to engine, then start engine. When engine starts, watch
gauges closely, and watch for abnormal readings.
Chapter 4_15_Axis.qxp_ Chapter 4 doc.qxd 6/19/14 10:32 AM Page 12
Содержание Wake Research
