AXIS Q6042-S PTZ Dome Network Camera
System Options
AXIS
Video
MIB
(Management
Information
Base)
for
video
hardware
can
be
used
to
monitor
Axis-specific,
hardware-related
issues
that
may
need
administrative
attention.
To
enable
and
configure
SNMP
in
the
Axis
product,
go
to
the
System
Options
>
Network
>
SNMP
page.
Depending
on
the
level
of
security
required,
select
the
version
on
SNMP
to
use.
Traps
are
used
by
the
Axis
product
to
send
messages
to
a
management
system
on
important
events
and
status
changes.
Check
Enable
traps
and
enter
the
IP
address
where
the
trap
message
should
be
sent
and
the
Trap
community
that
should
receive
the
message.
Note
If
HTTPS
is
enabled,
SNMP
v1
and
SNMP
v2c
should
be
disabled.
Traps
for
SNMP
v1/v2
are
used
by
the
Axis
product
to
send
messages
to
a
management
system
on
important
events
and
status
changes.
Check
Enable
traps
and
enter
the
IP
address
where
the
trap
message
should
be
sent
and
the
Trap
community
that
should
receive
the
message.
The
following
traps
are
available:
•
Cold start
•
Warm start
•
Link up
•
Authentication failed
Note
All AXIS Video MIB traps are enabled when SNMP v1/v2c traps are enabled. It is not possible to turn on or off specific traps.
SNMP v3
provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see
HTTPS on page 46
. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to Factory Default Settings on page 58
.
UPnP
TM
The Axis product includes support for UPnP
TM
. UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disabled under
System Options > Network > UPnP
RTP/H.264
The RTP port range and multicast settings are configured under
System Options > Network > RTP
.
The RTP port range defines the range of ports from which the video ports are automatically selected. For multicast streams, only
certain IP addresses and port numbers should be used.
Select
Always Multicast Video
to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
