Axis q1615 MK II, Руководство по установке

Страница: 18 / 136

AXIS Q1615 Mk II Network Camera
Function Pin Notes
RS485B alt
RS485/422 RX(B)
1
RS485A alt
RS485/422 RX(A)
2
RX pair for all modes (combined RX/TX for 2-wire RS485)
RS485/RS422 TX(B)
3
RS485/RS422 TX(A)
4
TX pair for RS422 and 4-wire RS485
Important
The maximum cable length is 30 m (98 ft).
Install the hardware
NO NO NOTICE TICE TICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use.
1. Optionally connect external input/output devices, such as alarm devices. See Connectors
on page 16 for information on the terminal connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
- PoE (Power over Ethernet). PoE is automatically detected when the network
cable is connected.
- Connect an external power adapter to the power connector block. See
Connectors on page 16 .
5. Check that the indicator LEDs indicate the correct conditions. See the table on page 11
for more details. Note that the Status LED can be configured to be unlit during normal
operation.
6. Optionally insert a microSD card (not included) into the SD card slot.
18