AXIS P5635-E Mk II PTZ Dome Network Camera
Setup
2. Create the preset position that covers the entrance of the gate and name it, for example, “Gate entrance”.
Create action rules
For the camera to open the gate when the PIR sensor detects someone nearby, you need to create an action rule in the camera:
1. Go to
System
>
Events
>
Action rules
.
2. Click
Add
.
3. Give the action rule a name, for example “Open gate”.
4. From the
Trigger
drop-down list, select
Input signal
.
5. Select
Digital input signal
.
6. Select ”PIR sensor”, in this example connected to port 1.
7. Under
Actions
, select
Output port
from the
Type
drop-down list.
8. From the
Port
drop-down list, select “Gate switch” .
9. Click
Ok
.
10. Create another action rule with the name “Direct the camera to the gate"
11. Select the same input signal as before, but as action select the previously created “Gate entrance” preset position.
12. Click
Ok
.
How to record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and to
stop one minute after.
Make sure audio turned on:
1. Set up the stream profile to include audio, see
How to add audio to your recording
.
Make sure the audio detection is set up:
2. Go to
Settings > System > Detectors > Audio detection
.
3. Adjust the alarm level according to your needs.
Create an action rule:
4. Go to
Settings > System > Events
and add an action rule.
5. Type a name for the action rule.
6. From the list of triggers, select
Detectors
and then select
Audio Detection
.
7. From the list of actions, select
Record video
and then select
Preset Position
.
8. Select the stream profile where audio has been turned on or create a new one.
9. Set the pre-trigger time to 5 seconds.
10. Set the post-trigger time to 60 seconds.
11. Select
SD card
from the list of storage options.
12. Click
Ok
.
12
