29
AXIS 262 - Hard Disk
To replace the hard disk:
1. Disconnect the power cable.
2. Unscrew the cover screws (two on each side and three on the back, see AXIS 262
rear panel, on page 7) of the AXIS 262.
3. Remove the cover.
4. Disconnect the hard disk’s IDE and power cables.
5. Unscrew the two screws that fix the hard disk bracket to the AXIS 262.
6. Remove the bracket, and loosen the screws that connect the hard disk to the
bracket.
7. Insert a new hard drive into the bracket and screw the bracket to the base of the
AXIS 262 again.
8. Attach the power and IDE cables, replace the cover and reconnect the power
cable.
Note:
Ensure that the jumper settings on the new hard disk are set to master.
Flash memory
b. Loosen the screws that
a. Disconnect power and
c. The hard disk bracket
can then be removed
Hard disk drive
IDE cables
fix the bracket to the base
