AXIOMTEK NA-1301, Руководство по установке оборудования

Страница: 30 / 55

NA-1301 Network Appliance Server Hardware Installation Guide
Attention: When you handle electrostatic discharge-sensitive (ESDs), take precautions to avoid
damage from static electricity.
3.4 Installing a memory module (DIMM)
The main board can supports two 184-pin DDR socket for a maximum total memory up to 4GB
Register
ECC Memory
.
The E7501 (north bridge) can support Single- and Dual-Channel Operation
1.
2.
In single-channel operation DIMM2 is disabled. Only DIMM1 need be added.
In dual-channel mode the memory populated in the two channels must be identical DIMM
configurations. The configuration consists of the same number of physical rows or banks(1 or 2),
row address bits, column address bits, the same technology part (128-Mb, 256-Mb,512-Mb), and
the same DRAM chip width (x4, x8). It is not necessary to match DIMM timings. A CL=2.0 DIMM
can be paired with a CL=2.5 DIMM as long as the geometry matches.
Attention: When you handle electrostatic discharge-sensitive (ESDs), take precautions to avoid
damage from static electricity.
3.5 Installing a DMA/66/100 hard drive
To accommodate the fast transfer rate of Ultra DMA/66/100, an 80-conductor cable (with 40 pin
connectors on both ends) is necessary when installing Ultra DMA/66/100 drives. The
NA-1301 , on this
aspect, can support a total of 2 Ultra DMA/66/100 drives. It is through the IDE Connector ( CN4 ) where
the 80-conductor cable is connected. The diagram below illustrates the proper installation procedure,
including color coding of connectors, of the 80-conductor cable.
Red stripe
represents pin 1 of
cable
Grey ATAS
TM
for
Slave Drive
Black ATAS
TM
for Master Drive
80-pin Ultra DMA/66/100 cable
Blue ATAS TM for
system board's
40-pin IDE
connector
ATA/66/100
Cable with
80 conductors
ATA/33
Cable with
40 conductors
Hardware Description
25