Operation instructions | SKT 40-00 | SKT 80-00 | 8PSK/QPSK | COFDM Quattro/Octo Module
12
2016-01-11 | © AXING AG Switzerland | Subject to change in design and type; errors and misprints reserved
3. Configuration
The device is configured via the graphical user interface of the integrated web interface.
To access the user interface, you need a standard PC/laptop with a network interface and the actual version of
the installed web browser. To connect the network interface of the module to the computer, you need a
commercially available network cable (e.g. Axing LAK 200-01).
The HTTP protocol is used for communication allowing a worldwide remote maintenance of the systems at
various locations via the Internet. Access protection is implemented by means of the password prompt.
The SKT 80-00 features two separate units that each have four tuners, four modulators and one HF output.
Every unit has its own web interface and its own static IP address. The following values are preset ex factory:
SKT 40-00:
IP address:
192.168.0.145
SKT 80-00:
IP address, left side:
192.168.0.145
IP address, right side:
192.168.0.146
Subnet mask:
255.255.255.0.
The computer and the module must be in the same subnetwork. The network part of the IP address of the
computer must be set to 192.168.0. and the subnet mask must be set to 255.255.255.0.
The host part of the network address is required for the identification of the devices and can be assigned in the
subnetwork only once. You can allocate to the computer any not allocated host address between 0 and 255.
Change the IP address and the subnet mask of your computer accordingly.
(e.g.: IP address:192.168.0.11 and subnet mask: 255.255.255.0)
Control panel > Network connections > LAN connection >Properties > Internet protocol version 4 TCP/IPv4 >
Properties > Use the following IP address:
Click OK to save.
Start your web browser and enter the IP address of the module: e.g.: 192.168.0.145.
