- 13 -
HOLDING THE VERIFIER
The Axicon verifiers are all designed to be used with the verifier
positioned flat over the barcode and touching the barcode, as shown in
the pictures below…
(This will ensure the most accurate results)
The Axicon 6025-S - Note that all
four corners of the verifier are
touching the label – it is neither
being “rocked” forwards or
backwards.
When using the 6525-S the verifier can
be operated either horizontally or
vertically (on the side of a carton) but
always in contact with the barcode.
The Axicon 7025-S being used – again
the verifier is in contact with the
barcode.
With all “S” range verifiers the verifier should be positioned slightly
above or slightly below the barcode, the trigger pressed and the the
verifier scrolled down the height of the barcode (as described in the
“Continuous scan section of the manual below)