DETAIL OF PHONEX REMOTER FOR MACROTEL X2
| DETAIL OF PHONEX REMOTER FOR MACROTEL X2
43
ATTEN:
when ATTEN is pressed, a dB reduction equal to the
“
Attenuation
” value set in the control software is applied to the
Receive signal. The ATTEN control becomes YELLOW.
HOLD:
when HOLD is pressed via software the Receive (Rx) volume is
taken to
–infinity without closing the call. The HOLD control becomes
RED.
DIAL:
when DIAL is pressed the DTMF dialler opens. Dial the
number using the numerical keyboard of your PC and then click ON
HOOK. In this way the DTMF dials the number to be called on the
telephone line. The Latest 10 Calls section displays the last ten calls;
click SAVE to permanently save a telephone number. To recall a
number double click on it.
Use the right button of the mouse to delete a number (Delete Row
#1) or all the numbers(Delete All) from the list of the Latest 10 calls.
The lower section displays the device statuses and any audio
functions enabled.
INPUT SOURCE:
this shows which source is connected to the Macrotel
X2 input. Analog, Microphone and Tone Gen are available.
The section below the Input Source shows if the “
Limiting
” controls are
enabled. The Line Status section displays the status of the
Ring and
Echo Canceller
controls.
15.3 LEVELS SECTION
The levels section shows the Macrotel X2 Input and Output levels of both telephone lines of
each hybrid. The
Operative Mode
area shows whether the Macrotel X2 device is operating in
SINGLE
mode, i.e. used as telephone hybrid for each single telephone line, or in
CONFERENCE
, i.e. sending to Telephone Hybrid 2 (
send
) what is received from Telephone
Hybrid 1 (
receive
) and sending to Telephone Hybrid 1 (
send
) what is received from Telephone
Hybrid 2 (
receive
). The
CONFERENCE
mode allows the two interlocutors to speak to each
other.
In this mode an audio signal can always be sent via the
SEND
input to both interlocutors. The
audio signal that comes, for example, from the
TELCO
channel of the mixer, which sends all the
mixer console’s audio signals,
WITHOUT
what arrives from the telephone channel, i.e. the
RECEIVE
. In this way an audio-loop with the telephone device is avoided.
