5min*
10min
15min
30min
45min
60min
120min
180min
OFF OFF (return to the home screen after 5 s)
*
if the TIMER mode is currently enabled, the first push of the button will display the current time until turning off.
• If the HIGRO mode has been enabled, when the TIMER is enabled, the HIGRO mode is disabled and the appliance starts running at speed 1.
• Changing the speed in the TIMER mode does not influence clock operation;
• After the set time has elapsed, the appliance will be turned off and the last used speed will be remembered.
• Activation of the TIMER mode is indicated by sequential lighting of the LEDs (top to bottom) in the central part of the display.
NIGHT (silent) mode:
• When activated, the night mode is started automatically at the selected clock time. Operation in the night mode ensures continuous ventilation of the room
with reduced noise emissions.
• To activate this function, push the na button on the remote controller. The activation/deactivation of the night mode is indicated with the following
messages:
• During operation in the night mode, the appliance automatically switches to RECUPERATION mode. The speed is determined by room humidity, according to
the following relationship:
- the measured humidity is lower than 70% - speed 1;
- the measured humidity is higher than 70% - speed 2.
Night mode start and end time setting:
• To set the night mode operation start and end hour, push the button and then (without releasing the button) push the button.
• The flashing “n On” message will be displayed on the screen.
• Next, use the (hours) and (minutes) buttons to set the desired night mode operation start hour (the first push of the button will display the
current set hour).
• After setting the desired night mode operation start hour, push the button again..
• The flashing “n OFF” message will be displayed on the screen.
• Next, use the (hours) and (minutes) buttons to set the desired night mode operation end hour (the first push of the button will display the
current set hour).
• After setting the set hour, push the button and then (without releasing the button) push the button.
Note:
By default, the set night mode operation time is 11 p.m. to 5 a.m.
Slider configuration (placed on the device controller):
Pairing the AHRTH temperature/humidity sensor:
• Check if the B2 slider is set to ON (permitted).
• Turn off the appliance, then press the button for 2 seconds.
A1
A2
ON
OFF
SW2
B1
B2
ON
OFF
SW1
EN
13
Function
Value
A1
ON
MASTER
SLAVE
same
opposite
permitted
non permitted
permitted
non permitted
OFF
ON
OFF
ON
OFF
ON
OFF
A2
B1
B2
Appliance type
SLAVE appliance
operating direction
Synchronous
operation
Communication
with BT sensor