Avocent AutoView 200, Инструкция по установке и эксплуатации, Страница: 20 / 60

14
AutoView 200/400 Installer/User Guide
To connect an extended access Sun user station (AutoView 400 only):
NOTE: This requires a VAK-1 adaptor kit available from Avocent.
Figure 2.4: Extended Access Sun User Station Installation
1. Plug a standard CAT 5 cable (up to 500 feet) into the RJ-45 modular jack on
the rear of the AutoView. Avocent C5T or P5T cable is strongly recommended
to achieve best performance and maximum distance. If you use a different
CAT 5 cable, ensure it is terminated to the EIA (TIA) 568 B standard.
2. Route the CAT 5 cable to the location where you intend to place the
secondary monitor, keyboard and mouse.
3. If your monitor uses a 13W3 plug, attach the 15HDD male adaptor into the
monitor port of your LongView receiver and the monitor cable into your VAK-1
adaptor. Otherwise plug the monitor directly into the LongView receiver.
4. Plug the ends of the 6-pin miniDIN VAK-1 keyboard/mouse adaptor into
the corresponding ports on your LongView receiver, then plug the Sun
keyboard/mouse cable into the VAK-1 adaptor.
REMOTE I/O
RECEIVER
–––+
24VDC
.5A
LongView
Sun User Station
VAK-1 Video Adaptor
13W3 Video Connector
Keyboard/Mouse
Connector
VAK-1 Keyboard/
Mouse Adaptor