984-0013-04
10
CPC: CPC Signal Detected.
LB: LOW or BAD BATTERY
XX: ACTIVE CALL FROM AN ELEVATOR (XX=01-64). Note: If more then one Elevator
is active the Display should show all numbers and switch between each number every
second. Example: Ports1, 3, 6 became active. Display should show 01 then 03 then 06
then back to 01, 03, 06 and so one...
LN: If there is a number programmed in the memory to call out with AUX1 enabled and
Telephone line is shorted or disconnected for more then 5 minutes.
VII
PROGRAMMING INSTRUCTIONS FOR HANDSFREE
PHONES CONNECTED TO THE EMS5
1. You can use your machine room or lobby master station phone or dial into the EMS5
from another phone. If you don’t have a master station available and you can’t dial
into the EMS5 you can plug a single line touch-tone phone into the “Local Service”
port of the EMS5.
2. Press * and the number of the elevator 01 through 64.
3. You will hear three double rings, the elevator phone should turn on and you will hear
a diddle-diddle-diddle sound.
4. Enter the programming pass code for the elevator phone. It will be # 94851 or
#9000000, listen for three beeps.
5. Disable the first number by entering # 0 * #, listen for three beeps.
6. Disable the second number dialer by entering # 1* #, listen for three beeps.
7. If the EMS5 is not connected to a phone line then enter the following code to disable
the voice message # * 1180180 * #. (The voice message is used by an off-site
location to identify the location.)
8. If the EMS5 is connected to a phone line, skip step 7 and program a location
message into the elevator phone by pressing # 7.
9. After the beep, talk into the Handset of your phone to record the message. If you
finish the message in less than nine seconds press “0”. The message will play back
for review. If you are not satisfied with the message, press # 7 and re-record the
message. If you want to review the message again press # 8.
10. Press # # to end programming. The phone will turn off.
VIII
OPERATING INSTRUCTIONS
WHEN CONNECTED TO A DEDICATED PHONE LINE AND MASTER STATION:
1. The Master Station will alarm with double rings.
2. The Display will show the number of the elevator calling in.
3. Pick up the handset on the Master Station and talk to the trapped passenger.
