984-0013-04
9
If the Hang up command was “#*”, you must program: *873(#*) #
*Note: The EMS5 will send the Hang-up tones in all of the following cases:
1. When the EMS5 detects the CPC from the line.
2. When the User hangs up the phone connected on Local Service Port.
*880# - Disables Call Progress Tones – (The call progress tones will stop after the unit
has made a call and it will not try to call a second phone number)
*881#- Enables Call Progress Tones – (Default)
*89X# -X=1-3 – Outgoing Voice message repetitions. (Default *891#)
•
Note: The Outgoing message could be stopped by using any DTMF tone if it’s set to
2 or 3 repetitions.
## - The EMS5 GIVES YOU 6 beeps exits programming and goes back on-hook.
**90# - CODE TO SET THE FOLLOWING CODES TO FACTORY DEFAULTS:
•
*1 445 #
•
*20 #
•
*30 #
•
*43 240 #
•
*44 0#
•
*5 000 #
•
*70 2 #
•
*72 1 #
•
*75 0#
•
*8 0 #
•
*87 1 #
•
*88 1 #
•
*89 1 #
VI
EMS5 ONBOARD DISPLAY CODES
When EMS5 first powers up it should scroll on the Display the following:
“EMS5 - FIRMWARE REV X.X.X.” – UNIT ID and then 2 Dashes.
X0: COMMUNICATION ERROR OR SHORT ON A DISPLAY CONNECTED TO COM-
OUT.
IC: When a Call comes in from an outside phone line. When the Call is answered by the
EMS5 or by the User on local port it should return to dashes.
PG: EMS5 is on programming mode.
