984-0013-04
7
•
Note: Outgoing messages will start to play only on an outgoing call from an
elevator port when the voice detection circuit of the EMS5 detects that the
call has been answered and the call waiting beeping stops.
•
Note: Incoming messages will start to play only on an incoming call when
the EMS5 is set up to answer incoming calls and after it plays the diddle-
diddle sound.
V
Additional Programming Commands
*1 A B C # (Default *1 445 #)
•
A – The number of incoming rings before answers incoming call, [0-8], default 4
Note: When A = 0, the EMS5 will not answer incoming calls from an outside line.
(Operator)
•
B – The number of rings to ring the local port from a call initiated from an elevator
port [0-8], default 4 (if the unit is programmed to call out it will do so after
completing ringing)
Note: When B = 0, the EMS5 will not Ring the Local Service Port when a call comes in
from an elevator phone but instead the elevator phone will use the phone line to call out
right away. Also local service port will be connected to the phone line so if the master
station goes off-hook it will hear dial-tone. If there is no phone line connected to the
EMS5 set “B” to 8 and delete all phone numbers by programming * 01 #, * 02 #, * 03 #.
This will cause the Local Service Phone (or Master Station) to ring 3 times the number
programmed into “B”.
•
C – The number of outgoing rings for each phone number [1-8], default 5
*05 Phone Number for Low Battery Backup Call#
Note: If the unit works off the battery and the battery voltage drops below 12VDC for 10
minutes it will make a call to this number.
Note: The Battery LED should also be blinking to indicate low voltage on battery. (Less
then 12 volts for more then 10 minutes)
**01 - Plays back the number as DTMFs
**02 - Plays back the number as DTMFs
**03 - Plays back the number as DTMFs
**05 - Plays back the number as DTMFs
*43 XXX # - Call Timer, Default XXX=240, range [060-990]
*44 X # - AUX1 Phone line monitoring output, Default: *44 0 #. (X=0-1, 0=Disabled,
1=Enabled)
Note: If AUX1 is enabled it will close within 5 minutes after the phone line is
disconnected from the unit and re-open within 5 minutes when the phone line is
