984-0013-04
8
re-connected. The AUX1 will also re-open if the unit is reset. If there are multiple
EMS5 call directors only the AUX1 of the master EMS5 needs to be connected.
*5 D E F #
- Optional programming command, Default *5000#.
•
D - When activated with “1” – It will not monitor dial-tone and always call out.
(Used for Ring Down mode lines)
•
E - When activated with “1” – If a call comes in from an elevator phone it will
Force the call externally even if someone answers call from local port. If
answered on local port and only if the call is acknowledged externally it will
function as a conference. The Local Port phone will not interfere with the
handling of the call but simply used for conferencing.
•
F - When activated with “1” – If a call goes out from an elevator phone the
EMS5 automatically sends ‘0’ to the elevator phone only when the call is
answered by the operator (on tone or voice mode) and the call is acknowledged.
*6 X # - Set Unit ID to X value, [0-7]
Note: The ID will set the Display to show different numbers as shown below:
ID ‘0’ = 01 – 08
ID ‘1’ = 09 – 16
ID ‘2’ = 17 – 24
ID ‘3’ = 25 – 32
ID ‘4’ = 33 – 40
ID ‘5’ = 41 – 48
ID ‘6’ = 49 – 56
ID ‘7’ = 57 – 64
*7 2 1 # - Enable CPC detection (Default)
*7 2 0 # - Disable CPC detection.
*75 1 # - Enable Automatic Rollover for Force-Thru Calling (When enabled the EMS5
will automatically turn OFF an active phone within 19 seconds after another phone has
been activated and connect you to the next phone on the line)
*75 0 # - Disable Automatic Rollover for Force-Thru Calling. The operator will still hear
call waiting tones when another phone becomes active but the call will not automatically
switch in 19 seconds. The operator must press *0 to talk to the next phone. (Default)
*8 0 # - Set Voice mode (Default)
*8 6 # - Set tone mode
*87X# - X=0: Disables Hang-up Tones.
X=1: Enable EMS-HANGUP TONES (“*0”) (Default)
X=2: Enable VPP-HANGUP TONES (“#”)
X=3(YZ): Sets Custom 2-Digit Hang-up command. (Acceptable commands: *, #, 0-9)
