EN
44
1 - WARNINGS
A automatic gate opening mechanism is a product
that can cause injury to people and animals and
damage to property. Our motorised gate as well
as its installation and user guides were designed to
remove all hazardous situations.
Avidsen cannot be held liable for any installation or
use that does not comply with the instructions and
causes damage.
It is essential to read the instructions carefully
before using your motorised gate and to keep these
instructions for any later use.
General Safety Obligations
•
This device is not intended for use by children or
persons with reduced physical, sensory or mental
abilities or lack of experience or familiarity, unless
they are supervised by someone responsible
for their safety or have been provided prior
instructions concerning the use of the device.
Children should be
supervised to make sure that they do not play
with the device.
•
All potential users must be instructed
in the use of the motorised gate by reading this
user guide.
•
No untrained person (child) must set the gate in
motion using the fixed (key selector) or portable
(remote control) devices.
•
Prevent children from playing near or with the
motorised gate.
•
Do not deliberately stop the moving gate,
except, of course, with a control device or for an
emergency stop.
•
Prevent any natural obstacles (branches, stones,
high grass, etc.) from hindering the gate’s
movement.
•
Do not manually operate the gate when the
motors are not disassembled.
•
Before setting the gate into motion, ensure that
there is no person in the area in which the gate
moves (children, vehicles, etc.).
•
In the event of a malfunction, disassemble the
motors to allow passage and contact your
installer. Do not attempt to fix the product yourself.
•
Do not alter or add components to the system
without discussing it with the installer.
2 - OPENING/CLOSING
The gate can be controlled from a programmed
remote control, a programmed wireless code
keypad or a wired control device.
2.1 - TYPE OF COMMAND
There are two types of command to manoeuvre the
gate:
Full opening command
Partial opening command (opening 1m20)
2.2 - OPERATING MODES
The operating mode is set by following the
instructions in the “operating mode” section.
2.2.1 - “SEMI-AUTOMATIC CLOSING” MODE
Description of operation from the closed gate
position:
To open the gate
•
Activate the complete (or partial) opening
command.
•
The flashing light will flash (1 flash per second).
1 second later, the gate will start and open fully
(1m20 for partial opening).
•
The flashing light will stop flashing and the
manoeuvre is complete.
To close the gate
•
Activate the complete or partial opening
command.
•
The flashing light will flash (1 flash per second). 1
second later, the gate will start and close fully.
•
The flashing light will stop flashing and the
manoeuvre is complete.
At any time, you can stop the gate’s movement by
activating a command (total or partial).
If you activate the gate control again, the gate will
start in the opposite direction.
E - USE
CONNECTED MOTOR DRIVE KIT
