EN
30
D - BEGINNING OPERATION
To choose the operating mode, set a value
from 1 to 3. Follow the procedure below
•
Press “
PROG
” for 3 seconds. L0 will flash 1 time.
and L1 will switch on.
•
Press “+” 3 times and L4 will switch on instead of
L1.
•
Press
SET
and the number of LEDs switched
on will then indicate the operating mode that has
already been set (mode 1 by default).
•
To change the operating mode, use
the “+” and “-” buttons, then confirm with the
SET
button.
At the time of this confirmation, the system will
detect whether there are photocells. Modes 2 and
3 requires the presence of photocells to protect the
gate’s passage when closing automatically (5.5.1 of
NF EN 12453 standard).
If photocells have not been detected when you
have set mode 2 or 3, the system reverts to
mode 1 by switching only LED L1 on.
•
If no photocells are connected, confirm mode 1
by pressing
SET
.
•
If photocells are connected, but not detected,
check that they are connected correctly and
correctly aligned.
•
If photocells have been detected, irrespective of
the mode set, all the LEDs switch on and off to
confirm the operation.
Note:
Irrespective of the mode, the system registers or
does not register the fact that the photocells are
connected to the electronic card.
The presence of photocells protects the passage
when the gate is closing and to ensure that they
are in working order, each time the gate starts to
close, the system performs the photocell detection
procedure. (photocell self-test).
If mode 1 (which is set by default) is the one desired
by the user, the user does not need to go to this
setting menu to re-enable mode 1, because the
photocells were already detected since they were
connected before the card was powered up.
2.7 - TIME DELAY
The time delay is the time during which the gate
remains open before closing automatically (if
automatic closing is activated).
To adjust this value, follow the procedure
below
• Press “
PROG
” for 3 seconds. L0 will flash 1 time.
and L1 will switch on.
•
Press “+” 4 times and L5 will switch on instead of
L1.
• Press “SET
”, and the number of LEDs lit will then
show the value set.
•
Use the “–” and “+” buttons to change this value
(see table below).
• Press SET
to confirm this value. All the LEDs will
turn on and off to confirm the operation.
This time is adjustable from 15 seconds to 90
seconds by 15 second intervals and is 30 seconds
by default.
LED on
L0
L1
L2
L3
L4
L5
Real time
15
secs
30
secs
45
secs
60
secs
75
secs
90
secs
3 - ADVANCED SETTINGS
Certain adjustments may be necessary in the event
of a problem or for specific use of the electronic
card.
There are two additional menus with basic settings.
3.1 - ACCESS TO ADVANCED SETTINGS (MENU
2)
To access the menus, follow the procedure
below
•
Press
PROG
for 3 seconds. L0 will flash once,
L1 will turn on and you will be in
menu
(basic
settings).
•
Press
PROG
again for 3 seconds. L0 will flash
twice, L1 will turn on and you will be in
menu
(advanced settings).
CONNECTED MOTOR DRIVE KIT
