AVGear AVG-CS4K-88-V2, Руководство пользователя

Страница: 19 / 32

AVG-CS4K-88-V2
Command Function Feedback Example
Save[Y].
Save the present operation to the preset command
[Y], range is from 0 to 9.
Save To FY (Y=0-9)
Recall[Y]. Recall the preset command [Y]. Recall From FY (Y=0-9)
Clear[Y]. Clear the preset command [Y]. Clear FY (Y=0-9)
PWON. Work in
‘normal’ mode.
PWON
PWOFF.
Enter into standby mode and cut off the power
supply to HDBaseT receivers.
PWOFF
STANDBY.
Enter into standby mode. (Do not cut off the power
supply to HDBaseT receivers, press any button or
send commands to start.)
STANDBY
/%[Y]/[X]:[Z].
HDCP management command.
[Y] is for input (value: I) or output (value: O); [X] is
the number of the port, if the value of X is ALL, it
means all ports; [Z] is for HDCP compliant status,
the value may be 1 (HDCP compliant) or 0 (not
HDCP compliant).
/%[Y]/[X]:[Z].
DigitAudioON[x].
Enable HDMI audio output of port x.

X=1 ~ 8 enable this port.

X=9, enable all ports.
DigitAudio ON with [x]
DigitAudioOFF[x].
Disable HDMI audio output of port x.

X=1 ~ 8 disable this port.

X=9, disable all ports.
DigitAudio OFF with [x]
/+[Y]/[X]:******.
Set communication between PC and HDBaseT
receiver.
①
Y is for RS232 port (connect with RS232 port of
HDBaseT receiver)
The value of Y is defined into the following
meanings (in a given baud rate depended by the
value of X):
a. Y = 1~8, send this command to the
corresponding HDBaseT receiver to control far-
end device.
b. Y = 9, send this command to all HDBaseT
receivers to control all far-end devices.
c. Y = A~H, under PWON mode, send this
command to the corresponding HDBaseT
receiver to control far-end device.
d. Y = a~h, under PWOFF mode, send this
command to the corresponding HDBaseT
receiver to control far-end device.
②
X is for baud rate, its value ranges from 1 to 7
(1--2400, 2--4800, 3--9600, 4--19200, 5--38400,
6
—57600, 7--115200)

***** is for data (max 48 Byte)
/+[Y]/[X]:******
EDIDH[x]B[y].
Input port [y] learns the EDID from output port [x].
If the EDID data is available and the audio section
supports not only PCM mode, then force-set it to
support PCM mode only. If the EDID data is not
available, then set it as initialized EDID data.
EDIDH4B3
EDIDPCM[x].
Set the audio section of input port [x] to PCM format
in EDID database.
EDIDPCM1
EDIDG[x].
Get EDID data from output [x] and display the
output port number.
Hexadecimal EDID data
and carriage return
character
EDIDMInit.
Restore the factory default EDID data of every
input.
EDIDMInit.