AVG-CS4K-88-V2
5.2.3 Controlling a Far-end Device from the Matrix location
Connect an 5V IR receiver to the IR IN on the Matrix Switcher. Use the IR Remote of
the far-end device to control the device locally.
Connect an 5V IR receiver with IR carrier to the IR IN port of the Matrix Switcher,
users can control a far-end output display via its IR remote locally.
In this case, the IR signal is transferred via twisted pair. Only the corresponding IR
OUT port can emit control signals to the remote display.
See the figure below:
Controlling a Far-end Device from the Matrix location
Note: The 5V IR receiver connected to
IR IN
must contain an IR carrier.
5.2.4 Controlling a Local Device Remotely
Connect 5V IR receiver(s) to IR IN on the far-end HDBT receiver(s), and 5V IR
Emitter(s) to IR OUT port of the switcher, and use the IR Remote of local source to
control the device remotely.
1 to 1:
Connect a 5V IR receiver to IR IN on far-end HDBT receiver, and an 5V IR Emitter
to IR OUT port of the switcher. Use the IR Remote of local source to control the
device remotely. See below:
